On the Go Mini Setup Guide

1. Attach the charging cable and Insert it into an electrical outlet that is not controlled by a light switch.
2. Place your On the Go Mini device in the charging cradle. If the battery is out of charge, it may take a few minutes for the device to announce, “Your device is now charging,” and the green flashing LED will appear. The red LED light will illuminate. When the red LED light goes out, your device is fully charged.
3. Your device is now ON and you will be ready to make a test call when there is adequate battery charge, and the device is connected to the cellular network. You will hear an announcement and the device will prompt you through the setup. The setup message will repeat until the button is pressed and the setup is complete.

1. Firmly press and hold the HELP button until the device beeps and announces, “Placing an emergency call now. To cancel the call please press and hold the HELP button for two seconds now.”
2. Allow the call to go through and speak to the response center.

Quickly press and release the Help button three times. Your device will announce, “Device is powering off. Please confirm by pressing and holding the HELP button now.”

Confirm by pressing and holding the Help button and the device will announce, “Powering off now, goodbye.”

Firmly press and hold the HELP button for one second or place it on the charging cradle.

To adjust the lanyard, hold one side of the loop and slide the barrel until the lanyard is at the proper length.

OPTION 1: Place the device face down on a table or other hard surface. Secure the band by pressing the nub in the desired hole on the band and slide the band under the attached loop.

OPTION 2: If you are not using the loop provided: Insert the band through the oval hole. Press the nub in the desired hole and the band will be secured underneath the wristband.

Fall Detection only takes a few seconds to interpret the movement and determine if an actual fall has occurred. If a fall is determined, the device will send a signal which will initiate a call to the emergency response center.

• We recommend that you wear your device around your neck so that it rests at chest level to avoid unnecessary swinging.
• Make sure the HELP button is facing forward, making it easier for you to press in an emergency.
• Wear outside your clothing as wearing it inside can reduce the percentage of falls being detected.
• To cancel a call made due to a fall detection event, after you hear the announcement, press the HELP button for two seconds when prompted. The device will announce, “Your call has been canceled.”

In certain situations, the fall detection feature may not detect a fall. Some movements include, but are not limited to:

• A gradual slide from a seated position
• Lowering oneself slowly to the ground (to brace the impact of a fall)
• A fall from a height of less than 20 inches

Certain conditions may affect the ability of the fall detection feature to detect a fall, including, but not limited to:

• Use of the system at an altitude above 6,600 feet
• Use of the system by a subscriber less than 4 feet 6 inches tall
• Use of the system by a subscriber weighing less than 88 pounds

However, the ability to send a help call by pressing the help button is not affected by such conditions.

If you are interested in purchasing the Fall Detection service or wish to learn more, please call 800-800-2537.